The Plans For Contructing
                             A Silver Box
                        Uploaded by Elric of Imrryr
                        Lunatic Labs R&D Division
                        Written by:Unknown


Howto build a SILVER box:


Toolsand materials :  Soldering Iron, Solder, Some 22 ga.
wire,a SPDT switch, and a screwdriver.


1)Unscrew your phone (must be a touch tone, desk type)
2)Remove the mounted pad and take the clear plastic cover from
thebottom.
3)Hold the pad with the numbers 0, *, # facing you, and turn
itupside down, so you can see the yellow pc board.
4)You should see 2 black round doughnuts.
5)Position the board so the solder points for the left
doughnut face you.
6)Count over four points from the left, and attach a (green)
wireto that point.
7)Between you and the doughnuts, there should be 2 long yellow
capacitors.  To the right of these, and on the edge of the
boardthere should be 3 gold contacts. We will use the one on
theleft.
8)The contact originally is spot welded, so snip it open.
9)To the one nearest you, attach a (red) wire to the other
one,a (yellow) wire.
10)Run the wires out of the phone, and solder the switch.
11)The orientation should be (red) to center. The switch will
nowalternate between normal and 1633hz fourth column tones.